Така ціна буде 1 день, далі поверну стару ціну.

Продам NewBeeDrone AcroBee65 BLV4 BNF ExpressLRS(ELRS) 2.4G 27000KV
Майже не літав ним, і то завжди в квартирі, ціленький.
Є ще комплект гвинтів з ним.
Батареї не дуже тримають, бо куплялись на початку 2024, відлежались.
Дрон перевірив зараз, все працює, піднімається норм.
Загалом цікава штучка, тільки надто резва. Продаю, бо просто лежить.

Відео про нього - youtube.com/watch?v=uBVAcaNW_YA

Specifications
AIO Flight Controller: BeeBrain BLV4 ELRS with built-in VTX and Crossfire Receiver
Motors: Flow 0802 27000kv Double Ball Bearing Brushless motor
Propeller: Azi Tri-Blade 31mm 1.0 Propeller (Clear Purple)
Frame: Cockroach65 Brushless Frame (Clear Purple)
Total Weight of the Drone without battery: 24.8g
Canopy: Goober Canopy (Clear Purple)
Camera: BeeEye Camera
Drone Size: 65mm
BEEBRAIN V4 AIO

Receiver: ELRS2.4 Diversity receiver(ESP32 compatible with wifi&bluetooth firmware update) 2.4G T-Antenna(Top) & normal 2.4G antenna(bottom)
VTX: Switchable output power from 5mw- 25mw(for Racing) - SmartMAX(SmartMax up to 400mw) with BeeTX 5.8Ghz Antenna
Battery input: 1-2S (Preset only support 1S, 2S will need throttle cap at less 50%)
Flight Controller Weight: 6.5g(Include antennas and battery connector)
ESC: 12A BLHeliS Pre-Flash with Bluejay 0.16 target: S-H-40 48kHz
OSD: NBD7456 Graphical OSD compatible with Betaflight OSD
Flight Controller Size: Outer dimensions: 29x29x7.6mm
Uart2: Tx&Rx for ExpressLRS2.4G Receiver
Power Connector: NBD-PH2.0 connector
Flight Controller: BeeBrain BLv4 ELRS
Flight Controller Holes: 25.5x25.5mm
ESC Connector: JST-1.0 3Pin
Uart1: Tx&Rx free
MCU: STM32F411

IMPORTANT NOTES

The 27000kv motor on your device is designed for high performance and may be too strong for most users. To ensure safety, the factory has set the device to only use 80% of the maximum power by default. However, if you require more power, it is possible to adjust the settings through the Betaflight software, which can be accessed under the PID tab. Please note that increasing the power beyond the default setting may increase the risk of damage to the device or injury to yourself or others, and should be done with caution.
Binding process: Power up the drone 3 times, on the third time you plug in power, and the ELRS Receiver will get into the binding mode.